[Ill.u.s.tration: TRAIL SET SNARES.]
The snare should be about nine inches in diameter and should be fastened securely to the tree. It should also be fastened lightly to the stakes on either side, so it will not spring out of shape. The best way is to make a little split in the side of each stake, and fasten the snare with a very small twig stuck in the split stake.
I make the snares of rabbit wire, about four or five plies thick, twisted. Some trappers prefer to use a cord. The dark colored codfish line is best, and it is best to use a spring pole snare, and Fig. 3 shows the method of tieing and fastening to the stakes. It will be seen that when the lynx pa.s.ses his head through the snare he only needs to give a slight pull to open the slip knot and release the spring pole.
To prevent the rabbits from biting a cord snare, rub it well with the dropping of the lynx or fox and also, never use any green wood other than spruce or balsam, as any fresh green wood is sure to attract the rabbits. You may also put a small piece of beaver castor along the trail on each side of the snare, and you will be more sure of the lynx, as beaver castor is very attractive to these big cats.
We will now proceed to make another spring pole snare, altho the one described before is more practical, says a Colorado trapper. It is made like the preceding one except the trigger, etc. This one is to be used on a runway without any bait whatever. The ill.u.s.tration shows the trigger as it appears in the runway. No. 1 is the trip stick; No.
2, the stay crotch; No. 3, the trigger; No. 4, the loop; No. 5, the pathway, and No. G, the stay wire.
[Ill.u.s.tration: PATH SNARE.]
The animal in coming on down the path (5) pa.s.ses its body or neck thru the loop made of stout soft insulated wire (4); in pa.s.sing it steps on the trip stick (1) which settles with the animal"s weight, releasing the trigger (3) which in turn releases the stay wire (6) and jerks the loop (4) around the animal; the spring pole onto which the stay-wire it attached lifts your game up into the air, choking it to death and placing it out of reach of other animals that would otherwise destroy your fur. A small notch cut in the stay crotch where the end of the trip stick rests will insure the trigger to be released. This will hold the trip stick firm at the end, making it move only at the end where the animal steps.
CHAPTER XVII.
BAIT SET SNARE.
This snare I consider good for such animals as will take bait. (See page 141.)
No. 1 and 2, headless wire nails driven horizontally into tree about ten inches from ground.
No. 3, a No. 10 or 12 wire nail with head used to catch under No. 1 and 2.
No. 4, bait stick or trigger. No. 3 pa.s.ses through No. 4.
No. 5, bait, frog tied to bottom of No. 4.
No. 6"s snare, fastened to No. 3 by two half hitches, then fastened to No. 3 by two half hitches, then fastened to seven or spring pole.
No. 7, spring pole.
Nos. 8, 8, small stakes driven in ground to form a pen.
Nos. 9, 9, two small twigs split at top to hold snare loop in place.
Nos. 1 and 2 should be about 4 inches apart.
No. 3 goes through a gimlet hole in No. 4. About three inches from the top use any small round stick from 1/2 to 1 inch in thickness, not necessary to flatten No. 4 as in ill.u.s.tration. Use it natural bark on. From hole in No. 4 to bottom end should be about 7 inches.
[Ill.u.s.tration: RAT RUNWAY SNARE. UNDERGROUND RAT RUNWAY. RUNWAY AND CUBBY SET. LOG SET SNARE. COW PATH SNARE.]
Snare loop about 6 inches in front of bait, held in place by 9, 9, slightly leaning against 8,8.
It can be plainly seen that if an animal takes No. 5 in its jaws and tries to remove it, it moves out the bottom of No. 4, moving forward No. 3 until, flip! up she goes. The top of No. 4 must be tight against the tree when set.
[Ill.u.s.tration: LIFTING POLE SNARE.]
No. 3 should just catch under No. 1 and 2, then it takes but 1/2 inch to pull on bait to spring it. Bait with frogs, fish, tainted meat for skunk, and pieces of rabbit, muskrat or bird, for mink.
The lynx, like the wolverine, is not afraid of a snowshoe track, and will follow a line of rabbit snare for long distances, and when he sees a bunny hanging up, he, without the least compunction, appropriates it to himself, by right of discovery.
When he does this once he will come again and the Indian hunter, knowing this, at once sets a snare for "Mister Cat." Sometimes when the thief has left a portion of the rabbit, a branch house is built up against the trunk of some tree, the remains of the rabbit placed at the back and the snare set at the doorway.
[Ill.u.s.tration: BAIT SET SNARE.]
A stout birch stick is cut about three or four feet long and lodged on a forked stick at each side of the door and about two and a half feet high. To the middle of this crossbar the end of the twine is tied; No. 9 Holland is generally used, or No. 6 thread cod line. This is gummed by rubbing balsam branches up and down the twine in the same way as the bear snare. The noose is held in shape in one or two places at each side by a light strand of wood or blade of gra.s.s and a couple of small dry sticks are placed upright under the snare to prevent the cat from pa.s.sing beneath.
The loop is almost as large as for a bear and as high from the ground, if not higher. The lynx has long legs and carries his head straight in front of him and takes a snare by pushing thru it, or by a rush, never crouching and then springing.
As the resort of rabbits is a young growth of country, there are also lynx in the greatest numbers. Rabbits and partridges are their princ.i.p.al food. When the Indian enters a new piece of country to set rabbit snares to support his wife and family and sees signs of lynx, he combines the two kinds of hunting and as he goes along, once in a while, he bars his snowshoe track by placing a lynx snare in the way.
The lynx are fond of the smell of castor, as indeed are most animals, so the hunter rubs a little on a tree at each side of his snare for the cat to rub against when he comes that way.
The snare is never tied to anything immovable, as they are very powerful and would break the twine. As soon as the noose tightens the cross piece comes readily away from the supports and the cat springs to one side. The stick, however, either knocks him a blow or gets tangled in his legs. This he tries several times, but with the same result, that bothersome stick is always hanging to his neck. About the last effort he makes to free himself is to ascend a tree. This, however, is nearly always fatal, for after he gets up a certain distance this trouble some stick is sure to get fast back of some limb. The lynx by this time, having become a pretty cross cat, makes matters worse and the hunter finds him hanging dead, at times twenty or thirty feet from the earth.
CHAPTER XVIII
THE BOX TRAP.
This trap is put to various uses. The beginner usually has one or two with which he traps for rabbits. In fact they are great for that for the animal is not injured, which is often the case when shot or caught by dogs. Rabbits caught in box traps are therefore the best for eating.
The trapper who wants to secure fur-bearers alive to sell to parks, menageries or to start a "fur ranch" usually uses the box trap.
The size for rabbits is about 30 inches long by 5 wide and 6 high.
The boards can be of any kind but pine, poplar, etc., being light is much used. The boards need only be a half inch thick. To make a trap you will need four pieces 30 inches long; two of these for the sides should be six inches wide; the other two for top and bottom should be 5 inches. These pieces should be nailed on the top and bottom of the sides. This will make the inside of the trap six inches high by four wide. It is best to have your trap narrow so that the animal you are trapping cannot turn in the trap.
In one end of the trap wires or small iron rods should be placed (see ill.u.s.tration). These should be about an inch apart. In the other end the door is constructed. This can be made out of wire also. The bottom of door should strike about eight inches inside. It will be seen that an animal pushing against the door, from the outside, raises it, but once on the inside the more they push against it the tighter it becomes.
[Ill.u.s.tration: THE BOX TRAP.]
The trap can be set at holes where game is known to be, or can be placed where game frequents and baited. If bait is used place a little prop under the door and place bait back in trap a foot or more. Bait to use of course depending upon what you are trapping.
The trap described is about right size for the common rabbit and mink. For skunk and opossum a trap a little larger will be required.
For mink and other animals that are gnawers the traps should be visited daily for they may gnaw and escape. If impossible to visit traps daily they should be lined with tin.
In many places these traps, with a door at each end, are used for catching muskrat. They are set in their dens under water and either tied or weighted down. The rats are caught either going in or leaving.
In making these traps the beginner is apt to make them too wide--so the animal can turn within. This is a mistake for it gives the game more freedom and room to gnaw to liberty.
The animal simply goes in and is there until the trapper comes along and removes the game. Skunk can be drowned when caught in this trap without scenting if the trapper knows how to go about it.