[Ill.u.s.tration]
NOTE--The above table is based on ordinary twist, 1.20 x square root of hank, with an allowance of 15 minutes per set for doffing and stops.
{117}
JACK FRAMES.
PRODUCTION PER DAY OF TEN HOURS.
[Ill.u.s.tration]
NOTE--The above table is based on ordinary twist, 1.20 x square root of hank, with an allowance of 15 minutes per set for doffing and stops.
{118}
FLOOR PLANS OF SPEEDERS.
SLUBBING FRAME R.H.
INTER, FRAME R.H.
ROVING FRAME R.H.
[Ill.u.s.tration]
NOTE--The HAND of a speeder is determined by the end on which the driving pulley is located when facing the spindles.
{119}
LENGTHS OVER ALL OF SLUBBING FRAMES.
[Ill.u.s.tration]
NOTE--If the projection of fender bracket be taken into account, add 2 inches to the above lengths.
{120}
LENGTHS OVER ALL OF INTERMEDIATE FRAMES.
[Ill.u.s.tration]
NOTE--If the projection of fender bracket be taken into account add 2 inches to the above lengths.
{121}
LENGTHS OVER ALL OF ROVING FRAMES.
[Ill.u.s.tration]
NOTE--If the projection of fender bracket be taken into account, add 2 inches to the above lengths.
If double boss rolls, the number of spindles must divide by four.
{122}
LENGTHS OVER ALL OF JACK FRAMES.
[Ill.u.s.tration]
NOTE--If the projection of fender bracket be taken into account, add 2 inches to the above lengths.
If double boss rolls, the number of spindles must divide by four.
{123}
[Ill.u.s.tration]
FRONT ELEVATION OF HEAD END GEARING--ROVING FRAME
{124}
[Ill.u.s.tration]
ELEVATION AND SECTION OF HEAD END GEARING--ROVING FRAME
{125}
ROVING FRAMES.
ALPHABETICAL REFERENCES TO DRAWINGS
[Ill.u.s.tration]
{126}
ROVING FRAMES-CONTINUED.
ALPHABETICAL REFERENCES TO DRAWINGS.
[Ill.u.s.tration]
{127}
SLUBBING, INTERMEDIATE, ROVING AND JACK FRAMES.
DRAFT CALCULATIONS.
[Ill.u.s.tration]
{128}
[Ill.u.s.tration]