793. The captain then causes the company to take intervals as described in the School of the Squad and commands: PITCH TENTS.
At the command PITCH TENTS, each man steps off obliquely to the right with the right foot and lays his rifle on the ground, the b.u.t.t of the rifle near the toe of the right foot, muzzle to the front, barrel to the left, and steps back into his place; each front rank man then draws his bayonet and sticks it in the ground by the outside of the right heel.
[Ill.u.s.tration: Plate VI.]
Equipments are unslung, packs opened, shelter half and pins removed: each man then spreads his shelter half, small triangle to the rear, flat upon the ground the tent is to occupy, the rear rank man"s half on the right. The halves are then b.u.t.toned together; the guy loops at both ends of the lower half are pa.s.sed through the b.u.t.tonholes provided in the lower and upper halves; the whipped end of the guy rope is then pa.s.sed through both guy loops and secured, this at both ends of the tent. Each front rank man inserts the muzzle of his rifle under the front end of the ridge and holds the rifle upright, sling to the front, heel of b.u.t.t on the ground beside the bayonet. His rear rank man pins down the front corners of the tent on the line of bayonets, stretching the tent taut; he then inserts a pin in the eye of the front guy rope and drives the pin at such a distance in front of the rifle as to hold the rope taut; both men go to the rear of the tent, each pins down a corner, stretching the sides and rear of the tent before securing; the rear rank man then inserts an intrenching tool, or a bayonet in its scabbard, under the rear end of the ridge inside the tent, the front rank man pegging down the end of the rear guy ropes; the rest of the pins are then driven by both men, the rear rank man working on the right.
NOTE.--The use of the hand ax and the pick mattock in organizations equipped with the intrenching tool is authorized for the purpose of driving shelter tent pins. The use of the bayonet for this purpose is prohibited.
The front flaps of the tent are not fastened down, but thrown back on the tent.
As soon as the tent is pitched each man arranges his equipment and the contents of his pack in the tent and stands at attention in front of his own half on line with the front guy-rope pin.
To have a uniform slope when the tents are pitched, the guy ropes should all be of the same length.
In shelter-tent camps, in localities where suitable material is procurable, tent poles may be improvised and used in lieu of the rifle and bayonet or intrenching tool as supports for the shelter tent.
794. When the pack is not carried the company is formed for shelter tents, intervals are taken, arms are laid aside or on the ground, the men are dismissed and proceed to the wagon, secure their packs, return to their places, and pitch tents as heretofore described.
795. Double shelter tents may be pitched by first pitching one tent as heretofore described, then pitching a second tent against the opening of the first, using one rifle to support both tents, and pa.s.sing the front guy ropes over and down the sides of the opposite tents. The front corner of one tent is not pegged down, but is thrown back to permit an opening into the tent.
SINGLE SLEEPING BAG.
796. Spread the poncho on the ground, b.u.t.toned end at the feet, b.u.t.toned side to the left; fold the blanket once across its short dimension and lay it on the poncho, folded side along the right side of the poncho; tie the blanket together along the left side by means of the tapes provided; fold the left half of the poncho over the blanket and b.u.t.ton it together along the side and bottom.
DOUBLE SLEEPING BAG.
797. Spread one poncho on-the ground, b.u.t.toned end at the feet, b.u.t.toned side to the left; spread the blankets on top of the poncho; tie the edges of the blankets together with the tapes provided; spread a second poncho on top of the blankets, b.u.t.toned end at the feet, b.u.t.toned side to the right; b.u.t.ton the two ponchos together along both sides and across the end.
TO STRIKE SHELTER TENTS.
798. The men standing in front of their tents: STRIKE TENTS.
Equipments and rifles are removed from the tent; the tents are lowered, packs made up, and equipments slung, and the men stand at attention in the places originally occupied after taking intervals.
TO PITCH ALL TYPES OF ARMY TENTS, EXCEPT SHELTER AND CONICAL WALL TENTS.
799. To pitch all types of Army tents, except shelter and conical wall tents: Mark line of tents by driving a wall pin on the spot to be occupied by the right (or left) corner of each tent. For pyramidal tents the interval between adjacent pins should be about 30 feet, which will give a pa.s.sage of 2 feet between tents.
Spread tripod on the ground where the center of tent is to be, if tripod is used. Spread the tent on the ground to be occupied, door to the front, and place the right (or left) front wall loop over the pin. The door (or doors, if more than one) being fastened and held together at the bottom, the left (or right) corner wall loop is carried to the left (or right) as far as it will go and a wall pin driven through it, the pin being placed in line with the right (or left) corner pins already driven. At the same time the rear corner wall loops are pulled to the rear and outward so that the rear wall of the tent is stretched to complete the rectangle. Wall pins are then driven through these loops. Each corner pin should be directly in rear of the corresponding front corner pin, making a rectangle. Unless the canvas be wet, a small amount of slack should be allowed before the corner pins are driven.
According to the size of the tent, one or two men, crawling under the tent if necessary, fit each pole or ridge or upright into the ring or ridge-pole holes, and such accessories as hood, fly, and brace ropes are adjusted. If a tripod be used an additional man will go under the tent to adjust it. The tent, steadied by the remaining men, one at each corner guy rope, will then be raised. If the tent is a ward or storage type, corner poles will now be placed at the four corners. The four corner guy ropes are then placed over the lower notches of the large pins driven in prolongation of the diagonals at such distance as to hold the walls and end of the tent vertical and smooth when the guy ropes are drawn taut. A wall pin is then driven through each remaining wall loop and a large pin for each guy rope is driven in line with the corner guy pins already driven. The guy ropes of the tent are placed over the lower notches, while the guy ropes of the fly are placed over the upper notches, and are then drawn taut. Brace ropes when used, are then secured to stakes or pins suitably placed.
800. Rescinded.
CONICAL WALL TENT.
801. Drive the door pin and center pin 8 feet 3 inches apart.
Using the hood lines, with center pin as center, describe two concentric circles with radii 8 feet 3 inches and 11 feet 3 inches.
In the outer circle drive two door guy pins 3 feet apart. At intervals of about 3 feet drive the other guy pins.
In other respects conical tents are erected practically as in the case of pyramidal tents.
TO STRIKE COMMON, WALL, PYRAMIDAL, AND CONICAL WALL TENTS.
802. STRIKE TENTS.
The men first remove all pins except those of the four corner guy ropes, or the four quadrant guy ropes in the case of the conical wall tent. The pins are neatly piled or placed in their receptacle.
One man holds each guy, and when the ground is clear the tent is lowered, folded, or rolled and tied, the poles or tripod and pole fastened together, and the remaining pins collected.
TO FOLD TENTS.
803. For folding common, wall, hospital, and storage tents: Spread the tent flat on the ground, folded at the ridge so that bottoms of side walls are even, ends of tent forming triangles to the right and left; fold the triangular ends of the tent in toward the middle, making it rectangular in shape; fold the top over about 9 inches; fold the tent in two by carrying the top fold over clear to the foot; fold again in two from the top to the foot; throw all guys on tent except the second from each end; fold the ends in so as to cover about two-thirds of the second cloths; fold the left end over to meet the turned-in edge of the right end, then fold the right end over the top, completing the bundle; tie with the two exposed guys.
METHOD OF FOLDING PYRAMIDAL TENT.
The tent is thrown toward the rear and the back wall and roof canvas pulled out smooth. This may be most easily accomplished by leaving the rear-corner wall pins in the ground with the wall loops attached, one man at each rear-corner guy, and one holding the square iron in a perpendicular position and pulling the canvas to its limit away from the former front of the tent. This leaves the three remaining sides of the tent on top of the rear side, with the door side in the middle.
Now carry the right-front corner over and lay it on the left-rear corner. Pull all canvas smooth, throw guys toward square iron, and pull bottom edges even. Then take the right-front corner and return to the right, covering the right-rear corner. This folds the right side of the tent on itself, with the crease in the middle and under the front side of tent.
Next carry the left-front corner to the right and back as described above; this when completed will leave the front and rear sides of the tent lying smooth and fiat and the two side walls folded inward, each on itself.
Place the hood in the square iron which has been folded downward toward the bottom of the tent, and continue to fold around the square iron as a core, pressing all folds down flat and smooth and parallel with the bottom of the tent. If each fold is compactly made and the canvas kept smooth, the last fold will exactly cover the lower edge of the canvas. Lay all exposed guys along the folded canvas except the two on the center width, which should be pulled out and away from bottom edge to their extreme length for tying. Now, beginning at one end, fold toward the center on the first seam (that joining the first and second widths) and fold again toward the center, so that the already folded canvas will come to within about 3 inches of the middle width.
Then fold over to the opposite edge of middle width of canvas.
Then begin folding from opposite end, folding the first width in half, then making a second fold to come within about 4 or 5 inches of that already folded; turn this fold entirely over that already folded. Take the exposed guys and draw them taut across each other, turn bundle over on the under guy, cross guys on top of bundle, drawing tight. Turn bundle over on the crossed guys and tie lengthwise.
When properly tied and pressed together this will make a package 11 by 23 by 34 inches, requiring about 8,855 cubic inches to store or pack.
Stencil the organization designation on the lower half of the middle width of canvas in the back wall.
WAR DEPARTMENT, OFFICE OF THE CHIEF OF STAFF, _Washington,_December_2,_1911._
Paragraphs 747, 792, 793, 794, 795, 796, 797, and 798. Infantry Drill Regulations, 1911, apply only to troops equipped with the Infantry Equipment, model 1910. For troops equipped under General Orders, No. 23, War Department, 1906, and orders amendatory thereof, the alternative paragraphs published herewith will govern.
By order of the Secretary of War:
LEONARD WOOD, _Major_General,_Chief_of_Staff_.
747. If the inspection is to include an examination of the blanket rolls the captain, before dismissing the company and after inspecting the file closers, directs the lieutenants to remain in place, closes ranks, stacks arms, dresses the company back to four paces from the stacks, takes intervals, and Commands: 1. _Unsling_, 2. PACKS, 3. _Open_, 4. PACKS.
At the second command each man unslings his roll and places it on the ground at his feet, rounded end to the front, square end of shelter half to the right.