It follows, therefore, that few troubles can be rightfully attributed to defects in the road, since what are commonly called defects are conditions quite normal to the country.
It was nearly six o"clock when we arrived at Fremont. The streets were filled with people in gala attire, the militia were out, --bands playing, fire-crackers going,--a belated Fourth of July.
When we stopped for water, we casually asked a small patriot,--
"What are you celebrating?"
"The second of August," was the prompt reply. I left it to the Professor to find out what had happened on the second of August, for the art of teaching is the concealment of ignorance.
With a fine a.s.sumption of his very best lecture-room manner, the Professor leaned carelessly upon the delicate indicator on the gasoline tank and began:
"That was a great day, my boy."
"Yes, sir, it was."
"And it comes once a year."
"Why, sure."
"Ahem--" in some confusion, "I mean you celebrate once a year."
"Sure, we celebrate every second of August, and it comes every year."
"Quite right, quite right; always recall with appropriate exercises the great events in your country"s history." The Professor peered benignly over his gla.s.ses at the boy and continued kindly but firmly:
"Now, my boy, do you go to school?"
"Yes, sir."
"Very good. Now can you tell me why the people of Fremont celebrate the second of August?"
"Sure, it is on account of--" then a curious on-looker nudged the Professor in the ribs and began, as so many had done before,--
"Say, mister, it"s none of my business--"
"Exactly," groaned the Professor; "it weighs a ton--two tons sometimes--more in the sand; it cost twelve hundred dollars, and will cost more before we are done with it. Yes, I know what you are about to say, you could buy a "purty slick" team for that price,--in fact, a dozen nags such as that one leaning against you,--but we don"t care for horses. My friend here who is spilling the water all over the machine and the small boy, once owned a horse, it kicked over the dash-board, missed his mother-in-law and hit him; horse"s intention good, but aim bad,--since then he has been prejudiced against horses; it goes by gasoline--sometimes; that is not a boiler, it is the cooler--on hot days we take turns sitting on it;--explosions,--electric spark,--yes, it is queer; --man at last stop made same bright remark; no danger from explosions if you are not too near,--about a block away is safer; start by turning a crank; yes, that is queer, queerer than the other queer things; cylinder does get hot, but so do we all at times; we ought to have water jackets--that is a joke that goes with the machine; yes, it is very fast, from fifty to seventy miles per--; "per what?" you say; well, that depends upon the roads,--not at all, I a.s.sure you, no trouble to antic.i.p.ate your inquiries by these answers--it is so seldom one meets any one who is really interested--you can order a machine by telegraph; any more information you would like?--No!--then my friend, in return, will you tell me why you celebrate the second of August?"
"Danged if I know." And we never found out.
At Bellevue we lighted our lamps and ran to Norwalk over a very fair road, arriving a few minutes after eight. Norwalk liveries did not like automobiles, so we put the machine under a shed.
This second day"s run was about one hundred and fifty miles in twelve hours and fifty-four minutes gross time; deducting stops, left nine hours and fifty-four minutes running time--an average of about fourteen and one-half miles per hour.
Ohio roads are by no means so good as Indiana. Not until we left Painesville did we find any gravel to speak of. There was not much deep sand, but roads were dry, dusty, and rough; in many localities hard clay with deep ruts and holes.
A six o"clock call and a seven o"clock breakfast gave time enough to inspect the machine.
The water-tank was leaking through a crack in the side, but not so badly that we could not go on to Cleveland, where repairs could be made more quickly. A slight pounding which had developed was finally located in the pinion of a small gear-wheel that operated the exhaust-valve.
It is sometimes by no means easy to locate a pounding in a gasoline motor, and yet it must be found and stopped. An expert from the factory once worked four days trying to locate a very loud and annoying pounding. He, of course, looked immediately at the crank- and wrist-pins, taking up what little wear was perceptible, but the pounding remained; then eccentric strap, pump, and every bearing about the motor were gone over one by one, without success; the main shaft was lifted out, fly-wheel drawn off, a new key made; the wheel drawn on again tight, all with no effect upon the hard knock which came at each explosion. At last the guess was made that possibly the piston was a trifle small for the cylinder; a new and slightly larger piston was put in and the noise ceased. It so happened that the expert had heard of one other such case, therefore he made the experiment of trying a fractionally larger piston as a last resort; imagine the predicament of the amateur, or the mechanic who had never heard of such a trouble.
There is, of course, a dull thud at each explosion; this is the natural "kick" of the engine, and is very perceptible on large single-cylinder motors; but this dull thud is very different from the hammer-like knock resulting from lost motion between the parts, and the practised ear will detect the difference at once.
The best way to find the pounding is to throw a stream of heavy lubricating oil on the bearings, one by one, until the noise is silenced for the moment. Even the piston can be reached with a flood of oil and tested.
It is not easy to tell by feeling whether a bearing on a gasoline motor is too free. The heat developed is so great that bearings are left with considerable play.
A leak in the water-tank or coils is annoying; but if facilities for permanent repair are lacking, a pint of bran or middlings from any farmer"s barn, put in the water, will close the leak nine times out of ten.
From Norwalk through Wakeman and Kipton to Oberlin the road is rather poor, with but two or three redeeming stretches near Kipton. It is mostly clay, and in dry weather is hard and dusty and rough from much traffic.
Leading into Oberlin the road is covered with great broad flag-stones, which once upon a time must have presented a smooth hard surface, but now make a succession of disagreeable b.u.mps.
Out of Elyria we made the mistake of leaving the trolley line, and for miles had to go through sand, which greatly lessened our speed, but towards Stony River the road was perfect, and we made the best time of the day.
It required some time in Cleveland to remove and repair the water-tank, cut a link out of the chain, take up the lost motion in the steering-wheel, and tighten up things generally. It was four o"clock before we were off for Painesville.
Euclid Avenue is well paved in the city, but just outside there is a bit of old plank road that is disgracefully bad. Through Wickliff, Willoughby, and Mentor the road is a smooth, hard gravel.
Arriving at Painesville a few minutes after seven, we took in gasoline, had supper, and prepared to start for Ashtabula.
It was dark, so we could not see the tires; but just before starting I gave each a sharp blow with a wrench to see if it was hard,--a sharp blow, or even a kick, tells the story much better than feeling of the tires.
One rear tire was entirely deflated. A railroad spike four and three-quarters inches long, and otherwise well proportioned, had penetrated full length. It had been picked up along the trolley line, was probably struck by the front wheel, lifted up on end so that the rear tire struck the sharp end exactly the right angle to drive the spike in lengthwise of the tread.
It was a big ragged puncture which could not be repaired on the road; there was nothing to do but stop over night and have a tire sent out from Cleveland next day.
While waiting the next morning, we jacked up the wheel and removed the damaged tire.
It is not easy to remove quickly and put on heavy single-tube tires, and a few suggestions may not be amiss.
The best tools are half-leaves of carriage springs. At any carriage shop one can get halves of broken springs. They should be sixteen or eighteen inches long, and are ready for use without forging filing or other preparation. With three such halves one man can take off a tire in fifteen or twenty minutes; two men will work a little faster; help on the road is never wanting.
Let the wheel rest on the tire with valve down; loosen all the lugs; insert thin edge of spring-leaf between rim and tire, breaking the cement and partially freeing tire; insert spring-leaf farther at a point just about opposite valve and pry tire free from rim, holding and working it free by pushing in other irons or screw-drivers, or whatever you have handy; when lugs and tire are out of the hollow of the rim for a distance of eighteen or twenty inches, it will be easy to pa.s.s the iron underneath the tire, prying up the tire until it slips over the rim, when with the hands it can be pulled off entirely; the wheel is then raised and the valve-stem carefully drawn out.
All this can be done with the wheel jacked up, but if resting on the tire as suggested, the valve-stem is protected during the efforts to loosen tire.
To put on a single-tube tire properly, the rim should be thoroughly cleaned with gasoline, and the new tire put on with sh.e.l.lac or cement, or with simply the lugs to hold.
Sh.e.l.lac can be obtained at any drug store, is quickly brushed over both the tire and the rim, and the tire put in place--that holds very well. Cement well applied is stronger. If the rim is well covered with old cement, gasoline applied to the surface of the old cement will soften it; or with a plumber"s torch the rim may be heated without injuring enamel and the cement melted, or take a cake of cement, soften it in gasoline or melt it, or even light it like a stick of sealing-wax and apply it to the rim. If hot cement is used it will be necessary to heat the rim after the tire is on to make a good job.
After the rim is prepared, insert valve-stem and the lugs near it; let the wheel down so as to rest on that part of the tire, then with the iron work the tire into the rim, beginning at each side of valve. The tire goes into place easily until the top is reached where the two irons are used to lift tire and lugs over the rim; once in rim it is often necessary to pound the tire with the flat of the iron to work the lugs into their places; by striking the tire in the direction it should go the lugs one by one will slip into their holes; put on the nuts and the work is done.
In selecting a half-leaf of a spring, choose one the width of the springs to the machine, and carry along three or four small spring clips, for it is quite likely a spring may be broken in the course of a long run, and, if so, the half-leaf can be clipped over the break, making the broken spring as serviceable and strong for the time being as if sound.
CHAPTER FIVE ON TO BUFFALO "GEE WHIZ!!"